Search Frequent Questions

Filter By:

Active filters:

Remove all filters

Displaying 1 - 15 of 38 results

  • What’s the difference between air sampling and air monitoring?

    Air monitoring and air sampling are two different methods of looking at air quality. Air monitoring uses electronic devices to provide real-time readings of contaminants in the air. Air sampling involves trapping air over a period of time in a container that is then sent to a laboratory for analysis…

    • Last published:

  • What is EPA’s role in sampling?

    EPA is part of the Unified Command consisting of different agencies to review, approve and direct Norfolk Southern’s workplans and site activities. Surface water sampling is performed by Norfolk Southern contractors, with EPA and Ohio EPA oversight. Soil sampling is performed both by Norfolk Southern contractors and EPA contractors. Air…

    • Last published:

  • What is the plume map and what does it tell us?

    The plume map is an “event reconstruction” based on known weather and on-site observations during a 10-hour time period after the vent-and-burn operation that occurred on Monday, February 6. It tells us where soot likely fell to the ground and where the highest concentrations of particles may be. This information…

    • Last published:

  • What is the “reduced speed” near work areas? When will the speed limit return to normal?

    The reduced speed near work areas on Taggart Street is 15 miles per hour. Be aware that air monitoring vans drive at 10 miles per hour and no passing is permitted. Please obey reduced speed signage to ensure safety of workers and work vehicles. Speed restrictions will continue until final…

    • Last published:

  • What hours will truck traffic be present? About how frequent and how long are wait times expected to be?

    Most truck traffic on Taggart occurs from 6 a.m. to 6 p.m. Vac trucks and support vehicles will continue to use the street through overnight hours. During traffic interruptions, wait times will likely vary from 15 to 30 minutes and may occur often throughout the day.

    • Last published:

  • Are there health risks to driving through Taggart Street?

    There are no anticipated health risks along Taggart Street associated with project activities. As work proceeds, to ensure worker and community safety, the Unified Command will continue to evaluate site conditions for health and safety considerations. While traffic will be able to proceed through the work areas along Taggart Street…

    • Last published:

  • When testing a work area, does one lead test kit or paint chip sample suffice for any single component?

    The certified renovator is only required to use one lead test kit or paint chip sample for each component, even if the surface of the component is extensive (e.g., a large wall). Question Number: 23002-23865 Find a printable PDF copy of all frequent questions pertaining to lead .

    • Last published:

  • Can a homeowner use an EPA-recognized lead test kit to check for lead-based paint?

    Answer: A number of lead test kits are available for consumer purchase in most retail hardware stores; however, the Consumer Product Safety Commission (CPSC) states that consumers should exercise caution when using these lead test kits to evaluate consumer products for potential lead exposures. Find more information online . To…

    • Last published:

  • How can I obtain D-Lead® test kits?

    The D-Lead® test kits are available for purchase from certain distributors and retail outlets. Locate a distributor or retailer online , email [email protected] or call 414-962-3006. Question Number: 23002-16390 Find a printable PDF copy of all frequent questions pertaining to lead .

    • Last published:

  • Is lead paint testing required under the Lead Renovation, Repair and Painting (RRP) Rule?

    No. A firm can either assume lead-based paint is present and follow the requirements of the RRP Rule (which requires no testing), or test and if lead-based paint is found follow the requirements of the regulation. Question Number: 23002-32338 Find a printable PDF copy of all frequent questions pertaining to…

    • Last published:

  • What is split sampling?

    Split sampling is a technique where multiple samples are collected from the same location at the same time and then sent to separate laboratories for analysis. Checking to see if the labs get the same or similar results is a way to determine the accuracy of the data. If there…

    • Last published:

  • What work happens after contamination under and between the train tracks is removed?

    After track work is complete, additional cleanup and assessments will continue. This includes shipping solid and liquid wastes off-site, excavating in areas where rail cars were staged and scrapped, and sampling and monitoring groundwater, soil, surface water, and sediment.

    • Last published:

  • Columbiana County Health District has sampled my private well, will it be sampled again?

    Residents will be contacted if they are within the priority zones and have signed up for private well sampling. Within 60 days after the first sample, private wells are resampled, and residents will be contacted to schedule resampling. Residents within one of the four priority zones can also schedule a…

    • Last published:

  • Can I get gas at Leake Oil on Taggart Street?

    No, Leake Oil is currently closed due to site activities. They have an alternate location on N. Market Street.

    • Last published:

  • What lead test kits are recognized by EPA?

    Answer: EPA recognizes three lead test kits for use in complying with the negative response criterion of the RRP rule. They are the Luxfer Magtech LeadCheck TM kit (for use on ferrous metal, plaster, drywall and wood), the State of Massachusetts kit (for use on drywall, plaster), and the D-Lead®…

    • Last published: