Search Frequent Questions

Displaying 1 - 15 of 23 results

• How do the changes in the 2006 Amendments apply to mobile refuelers?

  Mobile refuelers are now exempt from the following sized secondary containment provisions that still apply to all other bulk storage containers and mobile/portable bulk storage containers: • Sections 112.8(c)(2) and (11) for petroleum oils • Sections 112.12(c)(2) and (11) for animal fats and vegetable oils These provisions previously required sized…

  • Last published: June 5, 2024

• Can MOVES Report Output in Terms of Fuel Consumption?

  See More Frequent Questions about MOVES and Related Models . Although gallons of fuel consumed are not reported by MOVES, the factors used to convert total energy consumption (a MOVES reporting option) to gallons of fuel are contained in the FuelSubtype table (energy content, reported in kilojoules per gram of…

  • Last published: July 10, 2024

• In the past, EPA has, with the assistance of industry trade associations, produced fuels brochures for use at retail outlets explaining new fuel programs and addressing performance and air quality issues. Is EPA planning a similar effort with respect to t

  See More Frequent Questions about Fuels Registration, Reporting, and Compliance Help . In November 2005, the Clean Diesel Fuel Alliance was formed. Many public and private organizations are collaborating through the Clean Diesel Fuel Alliance to facilitate the introduction of ULSD. The U.S. Department of Energy (DOE), EPA, engine, vehicle…

  • Last published: August 1, 2024

• How do I use MOVES at Project Scale?

  See More Frequent Questions about MOVES and Related Models . The MOVES model can estimate emissions at national, county or project scale. Project scale is useful for estimating an individual transportation project like an intersection or transit project, but it requires detailed inputs that describing the vehicle population and activity…

  • Last published: August 2, 2024

• How Can I Determine the Effect of Speed on Vehicle Emissions?

  See More Frequent Questions about MOVES and Related Models . MOVES can be run in either “Inventory” or “Emission Rates” mode. With Emission Rates, MOVES reports emission rates for the 16 average speed bins used by MOVES for each hour of the day and additional emission rate output that may…

  • Last published: October 23, 2024

• SPCC Rule schedules for inspections, tests, and evaluations

  The SPCC rule requires inspections, tests, and evaluations of above ground containers (40 CFR §112.8(c)(6)). Does the rule set schedules for how often these need to be conducted? The SPCC Rule does not prescribe a specific frequency or methodology for performing the required inspections, evaluations, and tests for aboveground containers…

  • Last published: June 5, 2024

• Does MOVES Incorporate Anticipated Improvements in VOC Emission Factors Resulting from Improved Fuel Economy?

  See More Frequent Questions about MOVES and Related Models . Changes in fuel consumption affect VOC emissions by reducing refueling vapor losses and spillage. Other emissions (such as sulfates) are also affected by fuel consumption. MOVES incorporates changes due to fuel economy requirements that were finalized as of the date…

  • Last published: July 10, 2024

• Can I use MOVES to Model Emissions from Vehicles in other Countries?

  See More Frequent Questions about MOVES and Related Models . The MOVES model was designed specifically to model the emissions from vehicles and equipment designed to meet emission standards in the United States. There are considerable challenges to adapting the MOVES framework to other nations, primarily around the need for…

  • Last published: October 10, 2024

• How can I run MOVES3 for the entire U.S or for an entire year?

  See More Frequent Questions about MOVES and Related Models . The most accurate national MOVES runs are done for every county and hour and then averaged together in the output, but, depending on your intended use of the results, it’s also possible to pre-aggregate the MOVES inputs to run the…

  • Last published: December 19, 2024

• Are mobile refuelers exempt from integrity testing requirements?

  Pursuant to 40 CFR §112.8(c)(2), mobile refuelers are exempt from the secondary containment requirements for bulk storage containers. Are mobile refuelers also exempt from the requirements for integrity testing in §112.8(c)(6)? Since mobile refuelers are mobile or portable bulk storage containers, the other provisions of §112.8(c) still apply. Therefore, mobile…

  • Last published: May 31, 2024

• A tank truck common carrier picks up a load of ULSD at a Shell terminal and delivers it to a Flying J truckstop. The carrier only provides a transportation service, does that carrier have any registration or reporting duties?

  See More Frequent Questions about Fuels Registration, Reporting, and Compliance Help . No, the carrier does not have registration or reporting duties as long as taxes were assessed (in the case of highway fuel) or dye was added (in the case of NRLM) at the terminal. There are recordkeeping and…

  • Last published: August 2, 2024

• Will refiners produce No. 1 diesel fuel at 15 ppm sulfur? What other cold weather-gelling strategies are available to the end-user?

  See More Frequent Questions about Fuels Registration, Reporting, and Compliance Help . Yes, some refiners will produce No. 1 diesel fuel. There are also various other cold-flow improver additives currently on the market as well. Question and Answer was originally posted at Questions and Answers on the Clean Diesel Fuel…

  • Last published: August 2, 2024

• Many refiners currently make a jet fuel meeting <500 ppm requirements. If refiners make a jet fuel meeting 15 ppm requirements, there may be compatibility (safety or performance) issues for jet engine manufacturers. Have these manufacturers been consulted

  See More Frequent Questions about Fuels Registration, Reporting, and Compliance Help . The highway and nonroad diesel programs do not require that refiners produce 15 ppm sulfur jet fuel and do not set sulfur limits for jet fuel that is not designated as motor vehicle diesel fuel. This would be…

  • Last published: August 2, 2024

• What are the features available on the MOVES “Advanced Features” panel, and when would I use them?

  The MOVES graphical user interface (GUI) includes a panel for “Advanced Features,” which allows modelers to edit RunSpec inputs for preaggregation options and select input databases created by MOVES tools. The panel also includes some options that are obsolete or intended only for MOVES testing and development work. Each of…

  • Last published: December 19, 2024

• Can I model emissions from Electric, Fuel-Cell, and Hybrid Vehicles and Equipment in MOVES?

  See More Frequent Questions about MOVES and Related Models . Electric vehicles and equipment do not generate tailpipe or evaporative emissions like conventional vehicles. However, these vehicles do consume energy, leading to greenhouse gas emissions, and they generate brake and tire particulate matter (PM) emissions. MOVES includes electricity as a…

  • Last published: December 19, 2024